电线电缆网 > 国外线缆 > UL1150可以用XLPE做绝缘吗?(完整版)
UL1150可以用XLPE做绝缘吗? - 无图版
roger --- 2008-05-10 15:59:08
1
老二 --- 2008-05-11 10:21:58
2
性能能满足么?
appleseden --- 2008-05-11 11:04:11
3
Denny1980 --- 2008-05-11 15:59:15
4
UNDERWRITERS LABORATORIES INC. APPLIANCE WIRING MATERIAL
Subj. 758 Section 1 Page 1150 Issued: 1959-05-01
Revised: 2003-03-31
*Style 1150 Polyethylene Insulated, Shielded and Thermoplastic (PVC)
Jacketed Wire for Electronic Use.
______________________________________________________________________________
Rating 60°C, 300 Volts.
______________________________________________________________________________
Conductor No. 26-16 AWG, solid or stranded, tinned or bare.
______________________________________________________________________________
*Insulation Polyethylene or Flame-Retardant Polyethylene, 30 mils
minimum average thickness, 27 mils minimum at
any point.
______________________________________________________________________________
Shielding Shielding over conductor insulation shall consist of
No. 38-30 AWG, tinned or untinned copper strands applied
as a wrap or a braid or a wrap of aluminum faced “Mylar”
tape with a parallel uninsulated drain wire or a
conductive PVC shield with a parallel uninsulated drain
wire.
______________________________________________________________________________
*Jacket PVC, Class 43, 15 mils minimum average thickness, 13 mils
minimum at any point.
______________________________________________________________________________
Standard Appliance Wiring Material UL 758.
______________________________________________________________________________
Instructions Detailed Examination.
to UL Tensile Strength and Elongation of Insulation,
Representative before aging for Polyethylene and
for Flame-Retardant Polyethylene.
Tensile Strength and Elongation of Jacket same as
for Class 43.
* Spark Test.
______________________________________________________________________________
UL (4) Detailed Examination.
Counter-Check (4) Insulation, for Polyethylene and
Program for Flame-Retardant Polyehtylene.
(4) Jacket, Physical Properties, Class 43.
(4) Flexibility.
(4) Cold Bend.
* (12) Horizontal Flame Test.
______________________________________________________________________________
(Continued on Page 1150A)
UNDERWRITERS LABORATORIES INC. APPLIANCE WIRING MATERIAL
Subj. 758 Section 1 Page 1150A Issued: 1959-05-01
Revised: 2003-03-31
Marking General.
______________________________________________________________________________
Use For electronic use in non-hazardous locations.
roger --- 2008-05-12 16:36:45
5
XLPE:交联PE
性能满足,完全符合UL要求!
UL STYLE PAGE上没明确指出不能用XLPE啊
thchen --- 2008-07-04 15:44:12
6
minimum at any point.
不是明明说了PVC吗?用了LXPE就是 另一种线了!
roger --- 2008-07-16 09:40:55
7