电线电缆网 > 国外线缆 > 做好的2468铜包铝线氧化了还能用吗?(完整版)
做好的2468铜包铝线氧化了还能用吗? - 无图版
hxf1986 --- 2010-05-11 20:04:02
1
是2468 20 #一年前做好的线,现在一端打端子一端渡锡插板,焊好板后一拉,线芯就从中间断了,有氧化了的白色粉末。线还能用吗。
最先公司不懂,买了 很多铜包铝,现在还有。还能用吗
XINYAHYF --- 2010-05-12 08:33:43
2
铜包铝能做UL2468 20#的吗?铜包铝在UL758里面规定只可以做12#或以上的导体规格啊!
yincable --- 2010-05-12 08:51:37
3
最好不要用,铜包铝质量不好
bsdtdw --- 2010-05-12 13:37:22
4
唉,又是一个做水货的!
狼宇 --- 2010-05-12 18:28:10
5
呵呵
刪蒢記憶 --- 2010-05-12 20:39:05
6
UNDERWRITERS LABORATORIES | APPLIANCE WIRING MATERIAL |
Subj.758 | Section 2 | Page 2468 | Issued:1968-05-07 |
Revised:2008-05-27 |
Style 2468 | Flat Ribbon cable. |
Rating | 80 deg C, 300 Vac, Horizontal flame, Oil Resistant 60 deg C or 80 deg C (optional). |
Conductor | 32 AWG - 16 AWG solid or stranded round, tinned or bare copper.(铜) |
Insulation | PVC, 15 mils min average, 13 mils minimum at any point. |
Assembly | Two to one hundred and fifty conductors laid parallel and in one plane. Same or mixed AWG. Each conductor has a nominal 15 mils or heavier wall. This forms a flat cable with a single row of conductors having a 1/2 in. maximum width web between insulated conductors. |
Shield | Optional. |
Covering | (Optional) PVC, 5 mils min. at any point 80 mils max |
Standard | Appliance Wiring Material UL 758. |
Marking | General. |
Use | Internal wiring of Appliances; or internal wiring of Appliances where exposed to oil at a temperature not exceeding 60 deg C or 80 deg C, whichever is applicable. |
[刪蒢記憶 在 2010-5-12 20:39:31 编辑过]
moveitgogo --- 2010-05-13 12:33:10
7
对标准不熟悉!如果被UL查到了,罚款!
mybbbbb --- 2010-05-16 11:02:55
8
是12号以下吧。。
sanewcable --- 2010-12-03 14:48:25
9
悲剧 多长时间就氧化了捏??
7413617 --- 2011-07-16 10:34:37
10
铜包铝很脆,而且也容易氧化,你最好还是不要用了。
Cable888 --- 2011-07-19 16:55:23
11
CCA工艺不佳.
sihe2012 --- 2011-07-22 07:51:48
12
哈哈,你们偷工减料也太严重了,建议所有的线材导体不要用CCA,即使是非标线,因为很难焊锡也很容易断。品至很难保证.一般用来做个编制和缠绕和缠绕,还要在0.12以上.
hekejiu --- 2011-07-22 09:22:14
13
各位说的正确,CCA就只能用在屏蔽层方面,
liang905 --- 2011-07-23 08:37:40
14
I学习了
zongzi1111 --- 2011-07-30 10:16:01
15
铜包铝很脆,而且也容易氧化,你最好还是不要用了。
ailiayu --- 2011-08-11 11:20:23
16
CCA加工也不方便
1198340789 --- 2011-09-08 16:45:57
17
铜包铝也不是一无是处啊!总归各有所需吗,它存在就有它存在的价值
bsdtdw --- 2011-11-25 16:28:32
18
铜包铝并不是一无是处,但是要符合标准要求的,用在一些信号,如网络线等。
但是很多厂商,为了节约成本,用电镀的,更严重是,只有表面颜色是铜色,这样子做品质就无法保证了。
Cable888 --- 2011-11-25 18:47:06
19
CCA材质. 1, 本身无错.
2, 铜皮被偷工减料. < 15%.
3, 加工工艺不佳.
4, 误用 CCA 的特性.
web621 --- 2012-09-10 15:11:44
20
学习
cdyhyd --- 2013-02-01 15:01:54
21
现在太多做铜包铝的了,虽然不能否定所有的,但是水货确实多。
mr20408 --- 2013-02-25 14:48:47
22
原來這東西還有水貨...<div>
</div>
</div>